TechniSat 1 Satellite TV System User Manual


 
6 Operation
6.1 Switching on and off
> Switch on the receiver by pressing the On/Standby key on the remote control unit.
> Pressing this key again will switch off the receiver.
> The receiver is now in standby mode.
6.2 Programme selection
6.2.1 Using the Programme up/down keys
> You can move up and down the programme list one slot at a time by pressing the
Programme up/down keys aon the remote control unit.
6.2.2 Using the numeric keys
> You can use the numeric keys to enter the desired programme slot number directly.
For example
1 for programme slot 1
1, then 4 for programme slot 14
2, then 3, then 4 for programme slot 234
When entering programme numbers consisting of several digits, you have approx. 3 seconds
time after pressing a key to complete the entry.
If you wish to enter a programme number consisting of only one or two digits, you can speed
up the selection process by keeping your finger pressed down on the last digit a little longer.
6.2.3 Using the programme list (on screen):
> Press the OK key.
A programme list will now be displayed.
When TV mode is selected, only TV programmes will be displayed, and when Radio mode is
selected, only radio programmes will be displayed. The currently selected programme is hig-
hlighted in yellow.
> Now you can use the arrow up/down keys to mark the desired programme.
> Press the OK key to select the marked programme.
> Use the arrow up/down keys to move the marker up or down in the list one line
at a time.
> Use the arrow left/right keys to move backward or forward one page at a time.
16
DIGIBOX1_englisch.qxd 26.09.01 09:55 Seite 16