Filter
Top Products
Channel
In this line you should select the TV channel on which you want to record a programme:
> Mark the appropriate line Channel by means of the arrow keys.
> Press the OK.key.
A programme list will be displayed.
> Use the arrow keys to select the desired programme.
> Confirm by pressing OK.
The selected programme will now be taken over into the timer menu.
Date
> Use the arrow keys to mark the column Date.
> Use the numeric keys to enter the date on which you wish to record a programme.
Start
> Use the arrow key right to mark the column Start.
> Use the numeric keys to enter the starting time for the timer in this line.
Stop
> Repeat the steps as described under “Start” to enter the stopping/ending time.
In order for all events to be considered, there should be a break of at least one minute
between the stopping time of one timer setting and the starting time of the next timer
setting!
Repeat (optional)
> Use the arrow key right to mark the column Rpt.
> Press the OK key.
A selection window will be shown, with several repeating suggestions.
1x Timer on
T Daily repeat
1xW Repeat once a week
1-5 Repeat only on weekdays
6-7 Repeat only on weekends
> Select the desired function by means of the arrow up/down keys.
> The setting will be stored by pressing the OK key.
> When you have completed the programming, press the yellow function key in
order to store the data in memory.
> Press the TV/Radio key to return to normal operation.
Important Note!!!
Please ensure that the correct current time is displayed in the information window. If this not
the time, switch reception to a TV channel such as ZDF, that broadcasts current time, for at
least 30 seconds. This will enable your receiver to read the correct time into memory.
7 Changing the basic programming
7.1 Configuring programme lists
This chapter describes how you can change the pre-programming of your receiver, and how
you can change the user programme lists to suit your preferences. This function is also
required to sort newly found programmes into the lists after a programme scan has been
performed.
The following information provides a better understanding of the process:
To facilitate the finding of programmes, your receiver provides four user programme lists.
22
bed_anl_DIGITY 1_englisch_4.qxd 21.06.02 13:41 Seite 22