Filter
Top Products
7.2 Changing the PIN
The PIN number is set at the factory to 0000 in order to activate the parental control fea-
ture, you must enter a personal PIN number in place of the factory setting.
Please note! Do not forget your PIN number. If you do forget it, please con-
sult your retailer or serviceman!
In order to change the PIN number, proceed as follows:
> Press the Menu key to call up the Main Menu.
> Use the arrow up/down keys to mark the line Settings.
> Confirm by pressing OK.
The sub-menu Settings will be displayed.
> Use the arrow up/down keys to mark the line Change PIN.
> Confirm by pressing OK.
> Now use the numeric keys to enter the current PIN number (factory setting 0000).
> Now use the numeric keys to enter the desired new personal PIN number.
> Repeat this entry.
> When you have completed entering the PIN number in this manner, press the Back
key twice to return to normal operation.
Please note that the parental control feature must still be activated as described in Point 7.3.
7.3 Cancelling blocking of individual programmes
In order to remove the parental control feature for individual programmes, proceed as in
Point 7.2. After entering your personal PIN number, select the desired programme, and press
the OK key to remove the control feature.
When you have completed configuring the programme list according to your preference in
this manner, press the Back key twice to return to normal operation.
7.4 Programme Search
As mentioned before, your receiver is pre-programmed to receive signals from the ASTRA
and EUTELSAT satellites. In order to receive new programmes, or other satellites, there are
various options of searching fro programmes by means of a programme scan.
1. Satellite:
a) All, in order to scan all satellites selected in the menu LNB Settings (Point 5.4) for
available programmes
b) Satellite, in order to scan only the selected satellite for programmes or bouquets
2. Transponder:
Select this scanning option in order to search only a particular transponder of a satellite. This
will search individually for all programmes of a transponder.
When the scan has been completed, the screen will display information on the number of
programmes your receiver found, and how many of these are new. New programmes are
stored in the main programme memory list
and can then be entered in the user lists as
described in Point 7.1.
> Call up the Main Menu in order to commence your programme search.
26
bed_anl_DIGITY 1_englisch_4.qxd 21.06.02 13:41 Seite 26