Toshiba 15CV100U Flat Panel Television User Manual


 
29
Chapter 5: Setting up your TV
Programming channels into the
TV’s channel memory
When you press or on the remote control or
TV control panel, your TV will stop only on the
channels you programmed into the TV’s channel
memory.
Follow the steps below to program channels into
the TV’s channel memory.
Programming channels automatically
Your TV can automatically detect all active
channels in your area and store them in its
memory. After the channels are programmed
automatically, you can manually add or skip
individual channels in the channel memory.
Note:
You must configure the ANT/CABLE input
source before programming channels
( Page 28).
The automatic channel programming
process will erase channels that were
previously programmed into the TV’s
memory.
To tune the TV to a channel not
programmed in the channel memory, you
must use the Channel Number buttons on
the remote control.
Programming channels when the ANT/
CABLE input is configured for Cable will
take substantially longer than when the
antenna input is configured for Antenna.
This is normal; however, once channel
programming is finished, you should not
have to repeat the programming process
again unless your Cable TV service lineup
changes significantly.
To program channels automatically:
Programming channels manually
After automatically programming channels into
the channel memory, you can manually
programming individual channels.
To skip channels in the channel memory
To prevent certain channels from being viewed,
channel positions can be skipped.
Note: Skipped channels cannot be selected
with or ; however, they can still be
accessed using the number keys on the
remote control.
1
Configure the ANT/CABLE In input if you
have not already done so ( Page 28).
2
From the Setup menu, press or to
select Installation and then press .
3
Press or to highlight Terrestrial, and
press or to select Channel Program
and then press .
4
A screen will appear warning that previous
programs and settings will be deleted.
5
Press to start channel programming.
The TV will automatically cycle through all
the channels, and store all active channels in
the channel memory. When Auto Tuning is
finished, press or to view the
programmed channels.
1
From the Setup menu, press or to
select Installation and then press .
2
Press or to highlight Terrestrial, and
press or to select Channel Options
and then press . The list of channels will
appear.
3
Press or to select a channel position to be
skipped and then press
. A tick will appear in
the box. To remove the tick, press
again.
4
To save the setting, press .