Toshiba 15CV100U Flat Panel Television User Manual


 
49
Chapter 6: Using the TV’s features
Note: When you turn on the audio receiver,
change its input source, or adjust the sound
volume, the sound will be output from the
audio receiver’s speakers even if TV
Speakers has been selected. Turn the TV off
and on again to output the sound from the TV
speakers.
To set the REGZA-LINK
®
Setup:
Displaying TV status information
To display TV status information using
DISPLAY:
Press on the remote control.
The following information will display (if
applicable):
Current input (ANT/CABLE, Video, etc.)
If ANT/CABLE is the current input, either
“CABLE” (for cable TV) or “ANT” (for over-
the-air broadcasts).
Channel number (if in ANT/CABLE mode)
Channel label (if set)
Digital signal strength indicator (bar graph in
lower right corner of box; for ATSC signal only)
Stereo, Mono or SAP audio status (when HDMI
input mode, Dolby Digital or PCM)
Video resolution
Aspect ratio of incoming video signal (4:3 or
16:9)
V-Chip rating status
GameTimer (if set)
To display more TV information:
Press on the remote control again.
The following additional information will display
for off air digital channels (if applicable):
Title
Duration
Detailed description
Note: The location of the banner can be
moved to the top or bottom of the screen by
pressing or while the DISPLAY is on-
screen.
Understanding the auto power off
feature
The TV will automatically turn itself off after
approximately 15 minutes if it is tuned to a vacant
channel or a station that completes its broadcast
for the day. This feature functions in ANT/
CABLE mode only.
Understanding the last mode
memory feature
If the power is cut off while you are viewing the
TV, the Last Mode Memory feature
automatically turns on the TV when the power
is resupplied.
Note: If it’s possible, and you will be away
from the TV for an extended period of time,
you should unplug the power cord.
1
From the Setup menu, press or to
select REGZA-LINK Setup and then press
.
2
Press or to select Enable REGZA-
LINK and then press or to select On.
Note: If you select Enable REGZA-LINK
Off, the other items will be grayed out.
3
Press or to select the REGZA-LINK
Setup item you want to use and then press
or to select On or desired mode.
TV Auto Input Switch: On/Off
TV Auto Power: On/Off
Device Auto Standby: On/Off
Speaker Preference: TV Speakers/Audio
Receiver
4
To save the new settings, highlight Done and
then press .
To revert to the factory defaults, highlight
Reset and then press .