Filter
Top Products
61
Chapter 9: Advanced disc playback
Enabling A-B repeat mode (DVD/
VCD/CD)
To resume normal playback:
Press until Off appears on-screen.
Note:
• In some cases, subtitles for the repeated
scene may not display.
• The A-B repeat mode may not apply to
some DVD scenes.
• The A-B repeat mode is not applicable to
interactive DVDs and JPEG CDs.
Programmed playback/Random
playback
You can program the playback sequence of tracks
on a Video CD. Or you can set the TV/DVD to
play tracks at random.
For procedures applicable to audio/MP3/WMA/
JPEG, go to Page 65.
Note:
• The programmed and random playback
modes are not applicable to PBC-enabled
Video CDs.
• The programmed and random playback
modes are only applicable during the current
session. Once you eject the disc or turn off
the TV/DVD, these modes will be disabled.
Programming the playback
sequence (VCD)
1
During playback, press at the point
where you would like the playback loop to
begin. This sets your “A” point.
2
When the playback reaches the point where
you would like the playback loop to stop, press
again. This sets your “B” point.
The section between points A and B will be
played repeatedly in a loop until you turn off
the Repeat A-B mode.
A
AB
1
Press in stop mode.
2
Press or to select Mode, then press
repeatedly to select Program.
3
Press or to go to the right column. Press
or to select the playback position, then
use the Channel Number buttons (0-9) to input
the track for that position.
To program other tracks, repeat this step.
If you input a wrong number, press .
Play Mode
Mode : Program
Repeat : Off
Program Playback
1 9
Play Mode
Mode : Program
Repeat : Off
Program Playback