Filter
Top Products
Chapter 3: Using the remote control
28
REMOTE CONTROL KEY Toshiba TV CABLE
SAT
(satellite)
DVD) AUX (VCR)
RED Red* --- --- --- ---
GREEN Green* --- --- --- ---
YELLOW Yellow* --- --- --- ---
BLUE Blue* --- --- --- ---
Programming the remote control
to control your other devices
Your Toshiba TV remote control is preprogrammed to
operate most Toshiba devices. To program your TV remote
control to operate a non-Toshiba device (or a Toshiba
device that it is not preprogrammed to operate), follow
the steps below. For details on using the remote control to
operate the device, see page 26.
1無
In the remote control code table (
pages 29-30),
find the code for your device. If more than one code is
listed, try each one separately until you find one that
works.
2無
Set the
MODE SELECT
switch to the type of device you are
programming the remote control to operate — CABLE/
SAT (for a cable converter box or satellite receiver), DVD
for a DVD player, HTIB [home theater in a box] or BD),
or AXU (for a VCR or TV/VCR combo).
3無
While holding down , press the Channel Number
buttons to enter the 3-digit code for your device.
4無
To test the code, turn on the device, point the remote
control at it, and press
. See notes below.
•
If the correct code was entered, the device will
turn off.
•
If the device does not respond, repeat steps 1–4
using another code.
•
If the device does not respond to another code,
you will need to use the remote control that came
with the device.
5無
Remember to set the
MODE SELECT
switch
back to “TV”
to control the TV.
6無
For future reference, write down the code(s) you used:
DEVICE CODE DEVICE CODE
Note:
•
In addition to POWER, confirm that all necessary
keys on the TV remote control operate your device.
If some keys are not operational, repeat the device
code setup using another code (if other codes
are listed for your device). If, after trying all listed
codes, the necessary keys do not operate your
device, use the device’s original remote control.
•
Every time you change the batteries, you will need
to reprogram the remote control.
•
Some newer VCRs respond to either of two codes.
These VCRs have a switch labeled “VCR1/VCR2.”
If your VCR has this kind of switch and does not
respond to the codes for your VCR brand, set the
switch to the other position (“VCR1” or “VCR2”)
and reprogram the remote control.