Filter
Top Products
Copyright © 2003 TOSHIBA CORPORATION. All rights reserved.
52
Chapter 6: Setting up your TV
To check the system status:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3).
3. Open the SYSTEM STATUS menu, highlight SYSTEM
INFORMATION, and then press ENTER.
Setup
Installation
Sleep Timer
On/Off Timer
Digital Tuner Hold
• • • • • • •
Off
Slide Show Interval
• • •
2 Sec
Convergence
System Status
System Information
4. Use the x • buttons to scroll through the menu bar to
check the Product Information and Software Version.
OK
System Information
Product Information
Brand: Toshiba
Model: 57H93
IEEE-1394 GUID: 0000391428343803
OK
System Information
Software Version
1.0.7
Jul 21 2003 - 16:31:05
FW 2.1
To close the screen and return to the TERRESTRIAL menu:
Highlight OK and press ENTER.
To return to normal viewing: Press EXIT.
Restore Factory Defaults
To restore all settings and channels to their factory default
values:
1. Follow steps 1–3 above.
2. Use the x • buttons to scroll through the menu bar to
select FACTORY DEFAULTS.
3. The screen below left appears. Enter your PIN code (or
0000 if no PIN code has been set). The screen below right
appears.
To cancel the reset: Highlight NO and press ENTER.
To continue the reset process: Highlight YES and press
ENTER. The TV will turn off automatically after a few
seconds. After the TV turns off, unplug the TV power cord
and then plug it in again to complete the restore.
OK
System Information
Factory Defaults
This window provides the ability to reset
the TV settings.
Type in your PIN now (or “0000” if no PIN
has been set) to restore settings to their
factory default values.
OK
System Information
Factory Defaults
This window provides the ability to reset
the TV settings.
Type in your PIN now (or “0000” if no PIN
has been set) to restore settings to their
factory default values.
Press YES to confirm. After the TV
turns off, unplug it and plug it
back in to complete the reset.
!
Yes No
Checking system statusViewing the digital signal meter
You can view the digital signal meter for ANT 1 and ANT 2
digital TV input sources only.
To view the digital signal meter:
1. Press MENU and open the SETUP menu.
2. Highlight INSTALLATION and press ENTER. (A new set
of INSTALLATION menu icons will appear on-screen, as
shown in step 3 below.)
Setup
Installation
Sleep Timer
On/Off Timer
Digital Tuner Hold
• • • • • • •
Off
Slide Show Interval
• • •
2 Sec
Convergence
3. Open the TERRESTRIAL menu, highlight SIGNAL
METER, and press ENTER.
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
4. Use the yzx • buttons to select the antenna input and
digital channel whose signal you want to check.
Note: The digital channel number listed in the Signal Meter
screen does not correspond to an actual TV channel number.
Contact your local broadcasters to obtain the RF channel
numbers for your local digital stations.
Signal Unlocked
OK
0 Peak 0
Signal Meter
Antenna
Channel (Digital)
1
1
Signal Unlocked
OK
0 Peak 0
Signal Meter
Antenna
Channel (Digital)
1
134
To close the screen and return to the TERRESTRIAL menu:
Highlight OK and press ENTER.
To return to normal viewing:
Press EXIT.