Filter
Top Products
Chapter 5: Setting up your TV
25
Programming channels automatically
Your TV can automatically detect all active channels
in your area and store them in its memory. After the
channels are programmed automatically, you can
manually add or erase individual channels in the
channel memory.
Note:
•
You must configure the ANT/CABLE input
source before programming channels (
page 24).
•
The automatic channel programming process
will erase channels that were previously
programmed into the TV’s memory.
•
To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
•
Programming channels when the ANT/
CABLE input is configured for Cable will take
substantially longer than when the antenna
input is configured for Antenna. This is
normal; however, once channel programming
is finished, you should not have to repeat
the programming process again unless your
Cable TV service lineup changes significantly.
To program channels automatically:
1無
Configure the antenna input source, if you have
not already done so ( page 24).
2無
Press and open the Setup menu.
3無
Highlight Installation and press .
4無
(A new set of Installation menu icons will appear,
as shown below.) Open the Terrestrial menu,
highlight Channel Program to bring up the Start
Scan, and press again to begin channel
programming.
The TV will automatically cycle through all the
antenna channels, and store all active channels
in the channel memory. While the TV is cycling
through the channels, the message “Scanning
channels, please wait” appears (as shown above).
5無
To cancel channel programming, press on
the remote control (or highlight Cancel in the on-
screen display and press ).
When channel programming is finished, press
or to view the programmed channels.
Setting channel skip
To prevent certain channels from being viewed,
channel positions can be skipped.
1無
From the Setup menu, highlight Installation and
press .
2無
Press p or q to select
Channel Options
and press
. The list of channels will appear.
3無
Press p or q to select a channel position to be
skipped and press . A tick will appear in the
box.To remove the tick, press again.
(continued)