Filter
Top Products
20
Is your recorder ready?
• Refer to “INSTALLATION GUIDE” and finish the
necessary preparations.
• Turn on the connected equipment such as a TV or
audio system and select the input from the recorder.
Turning the power on
(This owner’s manual instructions are based on
the premise that all proper connections have been
completed and the TV is turned on.)
Press ON/STANDBY on the front panel of the
recorder or on the remote control.
When the power turns on, the ON/STANDBY indicator
changes from red (standby mode) to green (operation).
After a few seconds, a start-up screen appears.
The following icon appears at the top right corner of
the screen.
When this icon disappears, the recorder is ready to
operate. If the disc drive contains a disc, it takes a
little longer to start up.
Viewing TV channels through this recorder
After turning the power on, the recorder will output TV
channel signals to the connected TV (also in the stop
mode).
You can select a desired channel by pressing CH or
the number buttons.
(These buttons can select channels of a connected
cable box or satellite system, if “IR control” (
page
42, in “INSTALLATION GUIDE”) is set to “On”.)
Loading a disc
Check disc compatibility beforehand ( page 6, 7)
and use a proper playable disc.
Caution
• Keep your fingers well clear of the disc tray. Neglecting this
may cause serious personal injury. Keep a close watch on
children.
• Do not use a cracked, deformed, or repaired disc.
1 Open the disc tray.
Press
on the front panel or the OPEN/CLOSE
button on the remote control.
2 Insert a disc.
Disc without a cartridge
Insert with the playback side down.
There are two kinds of disc size. Place a disc to fit
the dish. If a disc is out of the dish, it may result in
damage to the disc or malfunction.
Place a disc in the
inside hollow.
Introduction
Before operating this recorder
ON/STANDBY button
CH buttons
ON/STANDBY button
ON/STANDBY indicator
ON / STANDBY
CH
INPUT SELECTREC MODE
DIMMERPROG/HDMI
ON / STANDBY
CH
INPUT SELECTREC MODE
DIMMERPROG/HDMI
OPEN/CLOSE button
button
Loading
e.g.
RD-XS52SU/SC_Ope_E_p020-024 04.9.3, 11:1220