Filter
Top Products
161
Recording
Playback
Editing
Library
Function setup
Others
Introduction
DVD recorder operation
AV record quality
HDD
DVD-RAM
DVD-R
You can select from 5 combined picture and sound
quality recording settings prior to actual recording.
Actual selection applied becomes the default setting for
normal recording or programmed recording.
• To make a combination of picture and sound
quality settings.
1)
Press / / / buttons to select the desired
item (“Mode”, “Rate”, or “Audio quality”)
.
2) Press ADJUST button to change the setting of
each item.
• To apply the combination of picture and sound
quality settings.
1) Press
/ / / buttons to select a media to
record on (HDD or DVD).
2) Press ADJUST button to change the setting.
You can confirm the available recording time for
the selected setting on the bottom screen.
3) Press ENTER button.
Notes
• A combination of picture and sound quality settings can be
set for the HDD and a DVD-RAM disc respectively.
• You can change the combination of picture and sound
quality settings also by displaying Quick Menu on LIBRARY
MENU or in stop mode, then selecting “AV Record Quality”.
Either of the above methods updates the setting of this
recorder.
• If you set “SP” or “LP”, you cannot select “L-PCM”.
• Depending on the sound quality settings, the upper limit for
the picture quality setting differs.
• You can adjust the manual rate for picture quality by
0.2 Mbps from 2.0 to 9.2. (You cannot set the rate from 1.0
to 2.0.)
Picture record mode
HDD
DVD-RAM
DVD-R
Adjusts problems with the brightness of video signals of
TV broadcasts or other external input.
Press
/ buttons to select the source, and / buttons
to select the mode.
(Only use this setting when you cannot adjust the
brightness satisfactorily with the Custom picture setting in
Picture/Audio settings (
Page 157) of this recorder.)
Important:
• This setting changes the video signal to record and the
recorded signal is not returned to the original state even
when this setting is changed after recording. When
duplicating from a VHS tape, if you can check the video
recording state beforehand, we recommend first playing
back for a while and checking the overall brightness
tendency, then setting an appropriate mode.
Standard:
The brightness of signals received with this recorder
and external input signals is adjusted automatically.
This is normally the setting to use.
Mode 1:
This setting is used to record the signals darker when
the screen is too bright.
Mode 2, 3, 4:
As the number rises, the signals are recorded brighter.
Use these modes to adjust the brightness.
SETUP
e.g.
HDD
DVD
Custom setting
Setting
Total recording time: 71min.
(with 4.7 GB unused)
Manual
6.6
Mode
Rate
Audio quality
Manual1
2
3
4
5
Setting 1 – – –
L-PCM
D/M1
SP
LP
Manual
Manual
6.6
4.6
2.2
6.0
3.2
SP
4.6
D/M1
L-PCM
D/M1
D/M2
D/M1
AV record quality
RD-XS52SU/SC_Ope_E_p149-164 04.9.3, 11:15161