Filter
Top Products
68
RF350U (E/F) Web 213:276
Chapter 6: Using the TV’s features
To set the CE-Link Setup:
1 Press Y and open the Setup menu.
2 Highlight CE-Link Setup and press T.
3 Press B or b to highlight Enable CE-Link.
4 Press C or c to select On.
Note: If you set Enable CE-Link to Off, the all other items
will be grayed out.
5 Press B or b to highlight the CE-Link setup item you
want to use, and press C or c to select On/Off or the
desired speakers mode.
• TV Auto Input Switch: On/Off
• TV Auto Power: On/Off
• Device Auto Standby: On/Off
• Speaker Preference: TV Speakers/Audio Receiver (See
details on the previous page.)
6 To save the new settings, highlight Done and press T.
To revert to the factory defaults, highlight Reset and
press T.
Using the HDMI settings feature
This menu consists of the 2 items shown below (new HDMI
capabilities) and will be grayed out on non-HDMI inputs.
Some HDMI legacy sources may not work properly with your
HDMI TV. If you experience any problems, please unplug
your HDMI cable first and then try setting the following
options (Lip-Sync Latency and xvYCC) to Off. Adjusting
these settings should allow your HDMI legacy source to
operate properly with your TV.
• Lip-Sync Latency: On
This option activates an audio/video display timing
adjustment function that allows HDMI source devices to
accurately perform synchronization automatically.
• xvYCC: On
This feature expands the color range of HDMI signals,
allowing input of wider color signals from HDMI sources.
The HDMI features require proper HDMI source devices. If
your HDMI source device does not support these features,
activating them on the TV will not have any effect.
Note: If your HDMI connection is capable of 1080p and/or your
TV is capable of refresh rates greater than 60Hz, you will need
a Category 2 cable. A conventional HDMI/DVI cable may not
work properly with these settings.
To set the HDMI Settings:
1 Select the appropriate HDMI input (HDMI 1, HDMI 2, or
HDMI 3).
2 Press Y and open the Setup menu.
3 Highlight HDMI Settings and press T.
4 Press B or b to highlight the item you want to set.
5 Press C or c to select On or Off .
6 To save the new settings, highlight Done and press T.
To revert to the factory defaults, highlight Reset and
press T.
Installation
CE-Link Setup
Blue LED Illumination High
Setup
Sleep Timer
PC Settings
HDMI Settings
Power-On Mode Power-Saving
Done
CE-Link Setup
Device Auto Standby
Reset
TV Auto Power Off
On
TV Speakers
Speaker Preference
TV Auto Input Switch
Enable CE-Link On
On
Done
CE-Link Setup
Device Auto Standby
Reset
TV Auto Power Off
On
TV Speakers
Speaker Preference
TV Auto Input Switch
Enable CE-Link On
On
Done
HDMI Settings HDMI 1
Reset
xvYCC On
Please unplug your HDMI cable first!
Once you have changed On/Off settings, please press
Done and wait for changes completed message.
Warning: DO NOT TURN OFF OR UNPLUG THE TV UNTIL
COMPLETED MESSAGE IS DISPLAYED!!
Lip-Sync Latency On
40RF350U_EN.book Page 68 Tuesday, August 7, 2007 10:59 AM