Filter
Top Products
76
RF350U (E/F) Web 213:276
Chapter 8: Troubleshooting
• Your TV remote control may not operate certain features
on your external device. Refer to the owner’s manual for
your other device to determine its available features. If
your TV remote control does not operate a specific
feature on another device, use the remote control that
came with the device (- pages 27–35).
• If the TV still does not act as expected, use the Reset
Factory Defaults procedure (- page 44).
Channel tuning problems
• Make sure the remote control is set to the correct device
mode (- page 24).
• The channel may have been erased from the channel
memory by the Channel Add/Delete feature. Add the
channel to the channel memory (- page 40).
• The channel may be blocked by the Channels Block
feature. Unblock the channel (- page 62).
• If you are unable to tune digital channels, check the
antenna configuration (- page 39). If you are still
unable to tune digital channels, clear all channels from
the channel list (- page 41) and reprogram channels
into the channel memory (- page 40). If you are still
unable to tune digital channels, use the Reset Factory
Defaults procedure (- page 44). Also see “TV stops
responding to controls” and “Other problems”
(- page 75).
Closed caption problems
• If the program or video you selected is not closed-
captioned, no captions will display (- page 56).
• If text is not available, a black rectangle may appear.
If this happens, turn off the closed caption feature (-
page 56).
• A closed-caption signal may not display correctly in the
following situations: a) when a videotape has been
dubbed; b) when the signal reception is weak; or c) when
the signal reception is nonstandard (- page 56).
Rating blocking (V-Chip) problems
• If you forget your PIN code: While the PIN code entering
screen is displayed, press E four times within 5
seconds. The PIN code you previously stored will be
cleared (- page 60).
• The V-Chip feature is available for the U.S. V-Chip
system only (- page 61).
No CE-Link operation
• The CE-Link feature is available for Toshiba CE-Link
compatible devices.
• Make sure the HDMI cables with the HDMI Logo
( ) are used.
• When the connected CE-Link device does not work
correctly after you have changed settings of the device,
turn off your TV and unplug the power cord, then plug
and turn on again.
• If several devices are connected, CE-Link feature may
not operate properly.
• Read the instruction manual furnished with the connected
CE-Link device.
HDMI problems
For HDMI cables
• Make sure to use cables with the HDMI Logo
() (- page 19).
For Legacy HDMI source
• Some legacy HDMI sources may not work properly with
the latest HDMI TV products, due to new standard
adoption. Unplug your HDMI cable first and then try
turning Off the HDMI settings (Lip-Sync Latency,
xvYCC) and your legacy HDMI source should operate
properly with this TV (- page 68).
40RF350U_EN.book Page 76 Tuesday, August 7, 2007 10:59 AM