Filter
Top Products
- 32 -
ENG
TROUBLESHOOTING
Disc does not play
Make sure the DVD disc surface is not damaged. (Scratch, fingerprint etc.)
Clean the DVD disc and try again.
Ensure that the DVD disc is on the drawer with the label facing up.
A damp DVD disc or condensation may effect the equipment. Wait for 1 to 2
hours in Stand-by to dry the equipment.
No disc in the player.
-Place a disc onto the tray.
Disc incorrectly loaded.
-Ensure that the DVD disc is in the correct guide on the disc tray with the
label facing up.
Wrong type of disc. e player Thcannot play CD-ROMS etc.
-Use disc with supported formats.
The region code of the DVD must match the one on the rear panel of the player.
.
Wrong OSD language
Select the language in the set-up menu.
The language for the sound or subtitles on a DVD cannot be changed.
Some functions (Angle, Zoom etc) do not work
No picture
Multilingual sound and/or subtitles not recorded on the DVD.
Try to change the sound or subtitles using DVD's title menu. Some DVD's do
not allow the user to change these settings without using the disc's menu
These functions are not available on the DVD.
Check that the player is connected to TV properly and all connections
between the DVD player and other attached equipments are secured.
Have you pressed the correct buttons on the remote control? Try once more.
.
.
.
No sound
Check whether the volume is set to an audible level.
.
Distorted sound
Check that the appropriate listening mode setting is correct.
No response from remote control
Make sure the remote control is in the correct mode.
Check whether the batteries are fitted correctly.
Change the batteries.
.
If nothing works
Never attempt to repair a defective DVD yourself.
If you have tried the above solutions and none seem to work, try switching your
DVD off and on again. If this does not work, contact your supplier or DVD repair
technician.
.
Make sure the TV TYPE and VIDEO OUTPUT are set correctly in VIDEO
SETUP menu.
Check whether the audio output connection is connected properly, see pages
14 to 17.
Operate the remote control within 30 angle on either side of the remote
control sensor, up to a distance of approximately 6 metres.
Operate the remote control on a straight path of the remote control sensor,
up to a distance of approximately 7 metres.
Angle can only be changed when the angle symbol is displayed.