Filter
Top Products
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
23
32/36AFX61(E)
Adding channels to the TV’s memory
When you press Channel y or z, your TV will stop only on the
specific channels stored in the TV’s channel memory. Follow the steps
below and on the next page to program channels into the TV’s
memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels. If you use both
ANT-1 and ANT-2 input sources, you must program channels for
each.
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z until TV/CABLE is highlighted.
3. Press x or • to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV. If you use
cable, highlight CABLE.
12345678910111213141516171819
20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
SET UP
LANGUAGE
CLOCK
ANT
ADD ADDERASE/
TV
CH
PROGRAM
TV/CABLE/CABLE
1 ANT1/2
SET
ENGL SHI
CORRECT ONI
T I LT
0
4. Press z to highlight CH PROGRAM.
SET UP
LANGUAGE
CLOCK
ANT
ADD ADDERASE/
TV
CH
PROGRAM
CABLE/CABLE
1 ANT1/2
SET
ENGL SHI
CORRECT ONI
T I LT
0
5. Press x or • to start channel programming. The TV will
automatically cycle through all the TV or cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
“Programming Now—Please Wait” appears.
6. When channel programming is complete, the message
“Completed” appears.
7. Press CH y or z to view the programmed channels.
MENU
yzx •
CH yz