Filter
Top Products
Page 11
If the Three Digit Code did not
work, try this next:
Auto-Search Method
The Auto-Search Method is a way you can scan
through all of the codes in the table to find the right
code for your component.
STEP 1: Manually or using your old remote, turn
on the component you want to program—for
example, to program your TV, turn on your TV set.
STEP 2: On the URC-A6, press the Component
button that you want to program (in this case the
button that says TV) and the SELECT [SEL] button at
the same time. Hold down both buttons for 2
seconds until the TV Component button light turns
on. This signals that you are in programming
mode.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 3: Point the URC-A6 remote control toward
the component and press the UP
5
arrow (or
DOWN
6
arrow) button once. Each time the UP
or DOWN arrow button is pressed, the code will
count up (or down) one code number and send a
Power OFF signal. When the correct code is sent
out, the component will turn off.
DOWN
6
ARROW
UP
5
ARROW