Filter
Top Products
Page 24
OSD (On-Screen Display) Control
“Punch Through”
This “Punch Through” enables you to program the
URC-A6 so that CBL or DVD OSD Controls
(MENU, GUIDE, INFO, EXIT, SEL and 4 Cursor
Controls) will also operate in other component
modes on the remote control.
STEP 1: Press and hold the component button you
want to add OSD Control to, such as TV or DVD,
and the SELECT [SEL] button at the same time for
two seconds until the Component LED light turns
on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the MENU button. The component
LED will blink once.
STEP 3: Press either the CBL or DVD button that
you want to use as the source of OSD Control. The
component LED will blink three times to confirm it
is saved.
SELECT
MENU
COMPONENT
BUTTONS