Filter
Top Products
Page 7
Programming URC-A6 using
Pre-Programmed Codes
There are three different ways you can program
your URC-A6 using the component brand codes
that are pre-programmed into the remote. One
of these will work for you!
• Quick Set-Up Method
• Three-Digit Code Entry Method
• Auto-Search Method
* * *
TRY THIS FIRST!
Quick Set-Up Method
STEP 1: Manually or using your old remote, turn
on the component you want to program—for
example, to program your TV, turn on your TV set.
STEP 2: Point the URC-A6 toward the component
that you want to program (in this case the TV set)
and press and hold the component button (in this
case the TV button).While holding down the
component button, begin to press the numeric
assigned to your brand in the Quick Set-up Code
Table(See Page 8) and release both Component
button and the number key to save the code.
The component LED light will blink three times to
confirm that the code has been stored.
STEP 3: Point the remote control at the
component.
STEP 4: Press the power button. If it turns
off, it is programmed for your component. If
it does not turn off, use the Pre-Programmed
Three-Digit Code Set-Up Method or Auto-Search
Method.
COMPONENT
BUTTONS
NUMBER
PAD