Filter
Top Products
Page 22
Channel Control “Punch Through”
This “Punch Through” enables you to program
the URC-A6 so that either the Cable or TV
Channel Controls (CHANNEL UP, DOWN,
LAST, CHANNEL NUMBERS 0-9, +10 and
ENTER) will also operate in other component
modes on the remote control.
STEP 1: Press and hold the component button
you want to add channel control to, such as
DVD or DVR, and the SELECT [SEL] button at
the same time for two seconds until the
Component LED light turns on.
IMPORTANT: You have 30 seconds to
perform the next step while you are in
programming mode. If you do not press a
button within 30 seconds, the component LED
light will turn off. The remote will exit the
programming mode and you will have to start
over.
STEP 2: Press the CHANNEL UP button. The
component LED light will blink once.
STEP 3: Press either the TV or CBL button that
you want to use as the source of channel control.
The component LED will blink three times to
confirm it is saved.
COMPONENT
BUTTONS
CHANNEL
UP
SELECT