Filter
Top Products
Page 23
Transport Control “Punch Through”
This “Punch Through” enables you to program
the URC-A6 so that DVD or DVR Transport
Controls (PLAY, STOP, FF, REW, PAUSE, SKIP and
RECORD) will also operate in other component
modes on the remote control.
STEP 1: Press and hold the component button
you want to add Transport Control to, such as
CBL or TV, and the SELECT [SEL] button at the
same time for two seconds until the Component
LED light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming
mode. If you do not press a button within 30
seconds, the component LED light will turn off.
The remote will exit the programming mode and
you will have to start over.
STEP 2: Press the PLAY button. The component
LED light will blink once.
STEP 3: Press either the DVD or DVR button that
you want to use as the source of Transport Control.
The component LED will blink three times to
confirm it is saved.
COMPONENT
BUTTONS
SELECT
PLAY