Filter
Top Products
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds,
the component LED light will turn off. The remote
will exit the programming mode and you will
have to start over.
STEP 2: Press the component button you want to
turn on and then the POWER button; repeat for all
other components in the order you want them to
turn on. The component LED lights will blink once
each time you press the POWER button.
STEP 3: Once you’ve entered all the Power On
commands, press the CHANNEL UP button to
save your MacroPower commands. The component
LED lights will blink three times to confirm that the
programming has been successfully saved.
SUGGESTION: Most of the components have
the same signal to turn the power On and Off.
You may want to program MacroPower only in
the POWER button and save the System Off button
to turn components On or Off individually.
Note: If you want to program MacroPower for the
SYSTEM OFF button, repeat the same steps used for
Power ON programming.
Page 18
COMPONENT
BUTTONS
CHANNEL
UP
POWER
AV-EXpertManual.qxd 7/12/07 6:41 PM Page 18