Filter
Top Products
Page 23
Channel Control ‘Punch Through’
This ‘punch through’ enables you to program the
AVEX R6 so that either the Cable or TV Channel
Controls (CHANNEL UP, DOWN, LAST, CHANNEL
NUMBERS 0-9, +10 and ENTER) will also operate
in other component modes on the remote control.
STEP 1: Press and hold the component button
you want to add channel control to, such as DVD
or VCR, and the SELECT [SEL] button at the same
time for two seconds until the Component LED
light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the CHANNEL UP button.
The component LED light will blink once.
CHANNEL
UP
SELECT
COMPONENT
BUTTONS
STEP 3: Press either the TV or CBL button that
you want to use as the source of channel control.
The component LED will blink three times to
confirm it is saved.
AV-EXpertManual.qxd 7/12/07 6:41 PM Page 23