Filter
Top Products
Transport Control ‘Punch Through’
This ‘punch through’ enables you to program the
AVEX R6 so that VCR or DVD Transport Controls
(PLAY, STOP, FF, REW, PAUSE, SKIP and RECORD)
will also operate in other component modes on the
remote control.
STEP 1: Press and hold the component button you
want to add Transport Control to, such as CBL or
TV, and the SELECT [SEL] button at the same time for
two seconds until the Component LED light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2: Press the PLAY button. The component
LED light will blink once.
Page 24
SELECT
COMPONENT
BUTTONS
PLAY
STEP 3: Press either the DVD or VCR button that
you want to use as the source of Transport Control.
The component LED will blink three times to confirm
it is saved.
AV-EXpertManual.qxd 7/12/07 6:41 PM Page 24