Venturer PLV76198E Flat Panel Television User Manual


  Open as PDF
of 16
 
GB-5
QUICK INSTALLATION
Whenyouturnonyourtelevisionsetforthersttime,besuretoplaceitonasolidstablesurface.Toavoiddanger,do
notexposetheTVtowater,oraheatsource(e.g.lamp,candle,radiator).Donotobstructtheventilationgridattherear
andbesuretoleavesufcientgapsaroundtheunitasshown.
1.Connect an antenna or Cable TV COAX cable to the TV's
antennainputjack.
2.Connectthepowercord.
3.Pressthe /ONbuttontoturnontheunit.
4.Usethe / buttontohighlightOSD Language,thenpress
the ENTER or button to select the menu language from
English/Español/Français.
5.Press the /  button to highlight Antenna, then use the
ENTERor buttontoselect“Air”,“CableSTD”,“CableHRC”,
“CableIRC”or“CableAuto“.
6.Usethe / buttontohighlightAutoScan,thenpressthe
ENTERor buttontoconrm.
7.The unit will immediatelysearch all channelsfor those with
adequatesignalstrengthandstorethosechannelswithsignals
inmemory.Theunitwilltakeafewminutestonishautoscan
and after this is completed, the unit will switch to the rst
channelfound.
TURNING ON THE UNIT FOR THE FIRST TIME
Thersttimeyouturnontheunit,theunitwillenterthesetupmode.Youcaneasilyfollowthepromptmessageonthe
screentocompletebasicTVsettings.
MakesuretheTVantennaorCATVcablehasbeenconnectedproperlytotheTVantennainputjackontherearof
thesystem.
IfyousubscribetoCableTVService,werecommendyoupick
"CableAuto",howeveryoumightndyougetimprovedresults
using"CableSTD","CableIRC",or"CableHRC"-theseare
differentstandardsusedbyvariousCableSystems.
2
3/8”
2
3/8”
7
7/8”
PLV76198S23E10 IB ENG.indd 5 9/8/2009 9:57:24 AM
 previous next