Filter
Top Products
Installation
16 Vidikron Vision Model 120 Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the Vision 120 installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video installation
specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1
Choose a location for the projector 17
2
If installing a Vision 120/CineWide or Vision
120/CineWide with AutoScope: Install fixed CineWide base
plate or AutoScope lens motor
24
3
Mount the projector 30
4
Connect the VHD Controller to the projector 31
5
Connect signal sources to the VHD Controller 32
6
Connect external controller to RS-232 port (optional) 37
7
Connect 12-volt trigger outputs to AutoScope lens motor
and/or other equipment (optional)
38
8
Connect projector, VHD Controller and lens motor (if present)
to AC power and power up
40
9
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation
40
10
Primary lens adjustments: projected image size (zoom),
position (shift) and focus
19, 41
11
Install CineWide anamorphic lens (optional) 42
12
CineWide lens adjustments: position, pitch (angle), geometry
and focus
44
13
Projector calibration: adjust the following for each input;
save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
51 through 58
Note