Filter
Top Products
40
Vidikron Vision Model 30 Owner’s Operating Manual
On-Screen Display Menus
Installation
Vision Model 30
Picture Adjust
Image Option
Projector Status
Installation
Service
ISF Calibration
Language
Picture Configuration
Keystone
Installation
Language
Picture Configuration
Keystone
OSD Position
OSD Timer
PIP/PBP Setup
Background Color
To access the Installation menu, press MENU, then press the ▲ or ▼ arrows to highlight
Installation and press ENTER. The Installation sub-menu will then appear (see above).
Press EXIT to return to the previous menu or press MENU to close all menus.
NOTE: When you change a setting in the Installation menu, the change takes effect immediately;
you do not need to press
ENTER afterwards. (Press EXIT to return to the previous menu or MENU
to exit.)
Press the ▲ or ▼ arrows to select from the available Languages: English, French, Spanish,
German and Italian.
Press the ▲ or ▼ arrows to select the projector’s Picture Configuration. The projector
can be installed on a ceiling or in a rear-screen configuration with one or more mirrors.
There are four settings: Floor Front, Ceiling Front, Floor Rear and Ceiling Rear.
To correct distortion resulting from the angle of the projection, select Keystone and use
the
◄ or ► arrows to make the image rectangular.
NOTE: Vidikron recommends that the keystone feature not be used unless absolutely necessary, as
it may cause artifacts in the image.
Press the ◄ or ► arrows to adjust the horizontal and vertical position of the OSD.
Press the ◄ or ► arrows to set the OSD Timer. This timer controls how long the menus
remain on-screen after selecting them. Select from 0 to 60 seconds, in 3-second increments.
When you set the OSD to 0, the menus remain on-screen until you hide them by pressing
MENU.
OSD Timer
OSD Position