Filter
Top Products
41
Vidikron Vision Model 30 Owner’s Operating Manual
On-Screen Display Menus
Background Color
To use the Picture-in-Picture or Picture-by-Picture features, press the ▲ or ▼ arrow
buttons to select PIP/PBP Setup, then press ENTER.
Select PIP/PBP Enable from the PIP/PBP Setup menu. Press
▲ or ▼ to select Off or
On, then press EXIT.
PIP/PBP Setup
PIP/PBP Enable
PIP Setup
PBP Setup
Press the ▲ or ▼ arrows to select PIP Setup, then press ENTER.
Press the ▲ or ▼ arrows to select PIP Off, Graphic in Video or Video in Graphic, then
press ENTER.
Press the
▲ or ▼ arrows to select PBP Setup, then press ENTER.
Press the ▲ or ▼ arrows to select PBP Off, Graphic by Video or Video by Graphic,
then press ENTER. Press EXIT to return to the Installation menu.
Press the ▲ or ▼ arrows to select the image Background Color (grey, blue or white). The
Background Color appears when no incoming signal is present.
PIP / PBP Setup
PIP/PBP Enable
PBP Setup
PIP Setup
Vision Model 30
Picture Adjust
Image Option
Projector Status
Installation
Service
ISF Calibration
Service
Service
White Balance
Gamma Selection
ICC Adjust
Image Over Scan
Video Black Level
Image Shift
Amplitude
Horizontal Masking
Fan Control
Lamp Reset Timer
RS-232 Baud Rate
Remote Control
Return to User OSD
To access advanced picture quality adjustments and projector controls, use the up- or
down-arrow buttons to highlight Service and press ENTER. Use the number buttons on
the remote to enter the Service menu passcode when prompted and press ENTER again.
Then, press MENU on the remote control.
NOTE: You only need to enter the Service menu passcode the first time you select that menu after
turning on the projector.