Filter
Top Products
45
Vidikron Vision Model 30 Owner’s Operating Manual
On-Screen Display Menus
The Vision Model 30 has been designed to incorporate setup and calibration standards
established by the Imaging Science Foundation (ISF). The ISF has developed carefully crafted,
industry-recognized standards for optimal video performance and has implemented a
training program for technicians and installers to use these standards to obtain optimal
picture quality from Vidikron video display devices. Accordingly, Vidikron recommends
that setup and calibration be performed by an ISF certified installation technician.
All signal types require separate processing. Therefore, you need to calibrate each and
every input separately.
To access the ISF Calibration menu, use the up- or down-arrow buttons to highlight ISF
Calibration and press ENTER. Use the number buttons on the remote control to enter the
ISF Calibration menu passcode, then press ENTER again.
NOTE: You only need to enter the ISF Calibration menu passcode the first time you select that
menu after turning on the projector.
ISF Calibration
ISF Calibration
Picture Adjust
White Balance
Gamma Selection
Blue Enable
Save ISF Settings
Splash Screen Timer
ISF Enable
Return to User OSD
Picture Adjust
White Balance
Gamma Selection
Blue Enable
Save ISF Settings
Vision Model 30
Picture Adjust
Image Option
Projector Status
Installation
Service
ISF Calibration
These settings are described in the “Picture Quality Adjustments” section (refer to
page 34).
These settings are described in the previous section, “Service.”
These settings are described in the previous section, “Service.”
This setting is described in the “Image Options” section (refer to page 36).
When you have finished calibration, select Save ISF Settings and choose “Save ISF Night“
or “Save ISF Day” to store your settings.
To recall stored custom image quality settings, select Load Saved Settings from the Image
Option menu (refer to “Image Options,” earlier in this section) and choose “Custom 1,” “ISF
Night“ or “ISF Day.” Or, simply use the corresponding buttons on the remote control (MEM1,
ISF NT and ISF DAY respectively).