Filter
Top Products
Vidikron Vision 50 Series Owner’s Operating Manual A-1
This Appendix describes how to personalize the ISF splash screen on the Vidikron Vision 50
Series DLP Projectors.
1. Connect a PC to the Vision 50 RS-232 port and establish a serial connection; refer to
RS-232 Connection and Port Configuration on page 67 if you need instructions.
2. Press MENU on the projector remote control. Use the up- or down-arrow keys to
highlight ISF Calibration and press ENTER. Use the number buttons on the remote
control to enter the ISF Calibration menu passcode, then press ENTER again.
3. Press MENU on the projector remote control. Then, select Splash Screen Timer from the
ISF Calibration menu.
4. Use the left- or right-arrow buttons to set the Splash Screen Timer. This timer controls
how long the startup (Vidikron/ISF logo) image stays on-screen after you turn on the
projector. The range is from 5 to 60 seconds in 1-second increments. For this procedure,
set it to 30 seconds and press EXIT.
5. In the HyperTerminal window, at the command prompt (>), type U1 followed by the
customer name, four or five spaces and the ISF calibrator name:
6. Press <Enter>.
7. Press MENU on the projector remote control. Then, select ISF Calibration from the Main
menu.
8. Select ISF Enable from the ISF Calibration menu and set it to On.
Appendix A. Personalizing the ISF Splash Screen
on the Vision 50
Only ISF-trained and -certified technicians should attempt this
procedure!
Note