Filter
Top Products
Installation
Vidikron Vision Model 65/Model 75 Installation/Operation Manual 25
4. If you are mounting the projector on a ceiling: Line up the four holes on the projector
ceiling mounting plate (included with the projector ceiling mount kit) with those on the
bottom of the projector.
5. Secure the CineWide base plate (and ceiling mounting plate, if needed) to the projector
with the M6x12mm screws (item #1) and nylon spacers provided with the CineWide lens
base plate.
3.5
Mounting the Vision 65/75
There are several methods for mounting the projector. Depending on your chosen
installation, one method may be more suitable than another.
Floor Mounting (Upright)In typical front and rear screen installations, the projector can be placed upright on a secure
and level surface such as a table or cart. Carts are useful when moving a projector during a
presentation or from site to site. If possible, lock the wheels when it’s in position to prevent it
from being moved during a presentation.
Ceiling Mounting (Inverted)For fixed installations, and for those that want the projector out of sight or have a limited
space for projector and audience, you can invert the Vision 65/75 and suspend it from the
ceiling using a specially-designed ceiling mount fixture.
The projector can also be inverted and placed in an enclosure above and behind the viewing
area. Install four feet on the inside bottom surface of the enclosure on which the projector
can rest. A variety of materials can be used for this purpose (for example, rubber crutch tips
or turntable feet).
The hole pattern on the CineWide base plate is identical to that on the
ceiling mounting plate.
1. Do not use the mounting screws provided with the ceiling mounting
plate. Use only the hardware provided with the CineWide lens base
plate.
2. DO NOT OVER-TIGHTEN THE SCREWS.
Note
Caution
Use only the Vidikron-approved ceiling mount kit designed for your
projector (part number 956-0259-00). Install the mount kit according to
the instructions provided with it.
Tighten all screws securely, but do not over-tighten them. This is
particularly important when ceiling-mounting a Vision 65/75/CineWide
with AutoScope, because the anamorphic lens and lens motor shift the
center of gravity toward the front of the projector.
Caution