Filter
Top Products
Installation
Vidikron Vision Model 65/Model 75 Installation/Operation Manual 37
Configure Lens Motor Trigger: CineWide with AutoScope maintains constant image height
independent of the aspect ratio, while using the full display resolution of the projector. It
accomplishes this by moving the anamorphic lens in front of the primary lens when
widescreen material is being viewed. When the viewer transitions back to 16:9 or 4:3 source
material, the anamorphic lens moves out of the light path.
To configure the lens motor trigger on the Vision 65/75 for proper AutoScope operation:
1. Press MENU on the remote control.
2. Select Setup from the Main menu and press ENTER.
3. Use the number buttons on the remote to enter the Setup menu passcode when
prompted and press ENTER again. Then, press MENU on the remote control.
4. Select 12-volt Trigger from the Setup menu.
5. Set the 12-volt Trigger to “Cinema.” This enables the lens motor to move the anamorphic
lens into position (in front of the primary lens) when the Cinema or IntelliWide 2.35
aspect ratio is selected.
6. Select the Cinema or IntelliWide 2.35 aspect ratio to move the anamorphic lens into
position, if it isn’t already. To do this, press CINEMA or IWIDE 2.35 on the Vision 65/75
remote control (
Figure 2-4).
Adjusting the Horizontal (X) Lens Position:
1. Project a white field on the screen.
2. Loosen the Yaw/X-Adjustment Levers underneath the lens.
3. Slowly move the anamorphic lens into place so that there are no shadows on either side
of the screen:
4. When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
Too Far Right
Too Far Left
Correct position