Filter
Top Products
Installation
Vidikron Vision Model 90t and Model 100t Owner’s Operating Manual 21
3.6
Connections to the Vision
90t/100t
Proceed as follows to connect the Vision 90t/100t to your video sources, external
controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure the cables are firmly connected. Tighten the thumbscrews on connectors that
have them.
Connector Panel AccessTo access the connector panel, press the
large, black door release button so it pops
out. Then, turn the knob clockwise or
counter-clockwise and pull gently on it to
open the door.
Connecting the Vision
90t/100t to Source
Components
Connect your video sources to the Vision 90t/100t as shown and described in the sections
that follow.
DVI Connections: See Figure 3-6.
Figure 3-6. DVI Source Connections
Use the DVI inputs whenever possible. This ensures the highest video
quality because the signal is carried in the digital domain throughout the
entire signal path, from source component output into the projector.
Tip
DVI 1
DVI 1
HD1
HD2
Y
G
G
Y
HV
INPUTS
HV
HD1
HD2
INPUTS
R
Pr
Pr
R
B
Pb
Pb
B
DVI 2
DVI 2
COMPONENT VIDEO
Pb
Pr Y
COMPONENT VIDEO
Y
Pr
Pb
VIDEO
VIDEO
S-VIDEO 2
S-VIDEO 2
S-VIDEO 1
S-VIDEO 1
RS-232
CONTROL
RS-232
CONTROL
IR
IR
1
2
3
123
TRIGGERS
TRIGGERS
DVI Source
(DVD Player or
HD Tuner with
HDMI or DVI out)