Filter
Top Products
Vidikron Vision Model 90t and Model 100t Owner’s Operating Manual 27
4.1
Turning on the Power
1. Turn on your source components.
2. Turn on the main power switch on the projector.
3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear of
the AutoScope lens motor. The lens motor power switch is located next to the AC input.
4. Press the ON button on the remote control – or the POWER button on the Vision
90t/100t rear panel – to turn on the projector. The vacuum fluorescent display on the
Vision 90t/100t rear panel briefly displays “Starting Display.”
5. When the projector is ready for use, the fluorescent display indicates the active source,
signal format (NTSC or PAL), input resolution and aspect ratio; for example:
4.2
Adjusting the Picture
Orientation
By default, the Vision 90t/100t is configured for a “floor/front” installation, in which the
projector is installed upright and in front of the screen. If it is installed behind the screen
and/or mounted on a ceiling, you must change the picture orientation. To do this:
1. Press MENU and enter the Service Menu passcode.
2. Select Service from the Main Menu.
3. Select Display Device from the Service Menu.
4. Select Installation from the Display Device menu.
5. Choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation method.
4Operation
Component SD NTSC 480i
Anamorphic Vidikron 90
Current Source Format
Input
Resolution
Aspect
Ratio
You must enter a passcode to access the Service menu.
Note