Filter
Top Products
Installation
26 Vidikron Vision Model 90t and Model 100t Owner’s Operating Manual
If your home theater contains a retractable screen, screen mask or other 12-Volt
trigger-activated equipment, connect it to a 12-Volt trigger output as shown in
Figure 3-12.
Figure 3-12. Connecting a 12-Volt Trigger Output to Other Equipment
Connecting to AC Power Plug the female end of the power cord into the AC receptacle on the rear of the Vision
90t/100t (AC 100V ~ 240V). Then, connect the other end to your AC power source.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power cord is
provided for the lens motor. Plug the female end of the AC power cord into the AC input on
the rear of the lens motor assembly. Connect the other end to a 110
VAC power source.
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
to 12-Volt
trigger-activated
equipment
3.5-mm
mini plug
Tip = +12V
Sleeve = Ground
➤
The input voltage to the AutoScope lens motor must be between 100 and
120 VAC. Do not connect the AutoScope lens motor to a 200-240
VAC
power source!
Caution