Vidikron VP-4200 Flat Panel Television User Manual


 
Installation
Vidikron PlasmaView Owner’s Operating Manual 19
PRE
L
IMINAR
Y
3.4
Connections to the
PlasmaView
Proceed as follows to connect the PlasmaView to your video sources, external controller(s) –
if present – and AC power.
When connecting your equipment:
Turn off all equipment before making any connections.
Use the correct signal cables for each source.
Ensure that the cables are securely connected. Tighten the thumbscrews on connectors
that have them.
Video ConnectionsConnect your video sources to the PlasmaView as shown and described in the sections that
follow.
RGB/Component Video (INPUT 1) Connection: Connect your personal computer or DTV
decoder with an RGB or component output to the ANALOG RGB IN input on the PlasmaView,
as shown in Figure 3-3.
Figure 3-3. RGB/Component Video (INPUT 1) Connection
1. The PlasmaView accepts “sync-on-green” and composite sync RGB
signals on INPUT1, as well as separate sync (RGBHV) signals. For more
computer signal compatibility information, refer to
Computer/Video
Signal Compatibility on page 70.
2. Some Macintosh computers may require a Macintosh video adapter.
Contact your nearest authorized service center or dealer.
3. INPUT 1 supports the VESA Display Data Channel (DDC 1/2B) standard.
This standard provides “Plug and Play” capability; the display and a
VESA DDC-compatible computer communicate their setting
requirements, allowing for quick and easy setup.
In order for Plug and Play to work correctly, you must turn on the
PlasmaView before you turn on the connected computer.
ANALOG RGB OUT
(D-Sub)
ANALOG RGB IN
(D-Sub)
INPUT1
Note