Vidikron VP-4200 Flat Panel Television User Manual


 
Serial Communications
54 Vidikron PlasmaView Owner’s Operating Manual
PRE
L
IMINAR
Y
Table 6-1 lists the PlasmaView serial command set. Except where indicated, adjustments
made using serial commands are stored in the same memory as those made in Installer
Adjust mode.
Table 6-1. Serial Commands
Command Value Range
Description
ASCII HEX Minimum Maximum
Power
POF 50 4F 46 Power OFF.
PON 50 4F 4E Power ON.
Input Select (Note 1)
IN1 49 4E 31 Switches the main screen to INPUT1.
IN2 49 4E 32 Switches the main screen to INPUT2.
IN3 49 4E 33 Switches the main screen to INPUT3.
IN4 49 4E 34 Switches the main screen to INPUT4.
IN5 49 4E 35 Switches the main screen to INPUT5.
INPS01 49 4E 50 53 30 31 Switches the main screen to INPUT1.
INPS02 49 4E 50 53 30 32 Switches the main screen to INPUT2.
INPS03 49 4E 50 53 30 33 Switches the main screen to INPUT3.
INPS04 49 4E 50 53 30 34 Switches the main screen to INPUT4.
INPS05 49 4E 50 53 30 35 Switches the main screen to INPUT5.
SSIS01 53 53 49 53 30 31 Switches the sub screen to INPUT1.
SSIS02 53 53 49 53 30 32 Switches the sub screen to INPUT2.
SWM 53 57 4D Outputs main input to the full screen.
SWS 53 57 53 Outputs sub input to the full screen.
Aspect Ratio
AST 41 53 54 Executes AUTO SETUP on Input 1.
SZMS00 53 5A 4D 53 30 30 Sets the aspect ratio to PIX by PIX.
SZMS01 53 5A 4D 53 30 31 Sets the aspect ratio to Standard 4:3.
SZMS02 53 5A 4D 53 30 32 Sets the aspect ratio to ANAMORPHIC
16:9.
SZMS03 53 5A 4D 53 30 33 Sets the aspect ratio to LETTERBOX.
SZMS05 53 5A 4D 53 30 35 Sets the aspect ratio to INTELLIWIDE.
Notes:
1. When making input-specific adjustments such as to image quality, screen position/size or audio
sub-volume, select the input you wish to affect before making such adjustments.
2. These settings are not stored in memory.