Filter
Top Products
Operation
46 Vidikron PlasmaView Owner’s Operating Manual
PRE
L
IMINAR
Y
Seamless Switch: This feature allows for high-speed switching between any two
PlasmaView inputs using the SWAP button on the remote control. To enable it, select
Seamless Switch from the Option menu and set it to ON. Then, specify the two inputs you
want to associate with this feature in the SELECT1 and SELECT2 fields.
By default, Input 1 and Input 2 are selected, so that when Input 1 is active, pressing SWAP
switches to Input 2 and vice versa.
Select Return to exit the Seamless Switch menu.
Picture Orient.: Select Picture Orient. to change the displayed image orientation to suit the
installation method; see Figure 4-8. For example, if the PlasmaView is suspended from a
ceiling, you may want to mount it upside down and run the cables upward (toward the
ceiling) to make them less visible. In this case, you would select “FLIP HV.”
Figure 4-8. Picture Orientation
Function Reset: To restore the PlasmaView to its factory-default state, select Function Reset
from the Option menu. Then, press
to highlight YES and press SET. This action resets ALL
settings (except the display ID Number) to their default values, as set at the factory.
Seamless Switch is not available when using PIP.
This action is not undoable. Proceed with caution!
Note
Up-down reversal
Normal operating state Left-right reversal
Up-down, left-right reversal
OFF FLIP H
FLIP HV FLIP V
Caution