Filter
Top Products
4
Mounting ViewSonic display to the wall
The display can be used in a free standing position or wall-mounted. Before installing
the product to the wall, please consider the following guidelines:
• Read the Important Safety Instructions, at the start of this manual.
• Do not install in a moist or wet environment. This equipment is intended for
indoor use.
• Do not install near heat source, or strong magnetic fields.
• Use only ViewSonic approved wall-mounting brackets to support the display
weight.
• Before attaching the wall mount plate to the back cover, ensure the product is
working.
• If your display is already set up for free-standing operation, you need to first
remove the stand before mounting the device to the wall.
To attach the wall-mount bracket to display safely, please use the following
guidelines:
• Disconnect the power and any other cables that might hinder moving the
display.
• Set the display on a table or work surface, placing the screen face down on
a towel or woolen blanket to protect the screen surface from damage while
installing plate.
• Before installing the display on the wall, ensure you have recorded the product
serial number on page (i) of the User Guide, as you will need the serial number
to request service should there be a service need.
• Install the wall mount plate to the display using screws NO LONGER than
20mm, as longer screws found in universal (non-ViewSonic) wall mount kits
may damage the power supply causing the unit to fail.
The wall-mount screw type is M6 x L20.
• Mount the wall mount bracket to the wall ensuring use of proper screws to
support the installation. Ensure there is at least 3cm of space surrounding any
air-vents of your display to allow adequate cooling during operation.
• Hang the display wall mount plate to the wall mount bracket, completing
installation.
Enjoy your ViewSonic display!