Filter
Top Products
VIVOTEK
16 - User's Manual
Initial Conguration
1. The system power on self test and OS initialization takes about 2 minutes to complete. Once
your NVR is started, you will be prompted by the Setup Wizard. You should then begin the
initial setup. The system is booted from an embedded IDE ash. No software installation is
required.
2. Enter the default User name and Password as admin & admin. It is recommended you
change the password later to prevent unauthorized access.
3. Click Next to proceed with conguration and follow the onscreen instructions to nish the
conguration process.
4. Note the following when you move to the Network page:
4-1. If your local network has a DHCP server, you can select the "Get IP address
automatically (DHCP)."
4-2. If your LAN port connects to an isolated switch with cameras attached to it, you can
manually assign IP addresses to cameras, and the address for the LAN port itself.
The default static IP for the LAN port is 192.168.1.10.
During boot-up, a Startup Menu will prompt allowing you to restore system to factory defaults.
This function is only required in circumstances that you need to renew all system settings, such
as moving the NVR to a different installation site or network environment.
NOTE:
1. NVR System