Filter
Top Products
VIZIO RP56 User Guide
040330 34
Programming the Universal Remote Control
The TV Selection button has already been programmed to work with your Vizio RP56 DLP TV (program
code 0080). You can program the other seven Component buttons on the Universal Remote Control to
operate other components you have.
1. Turn on the component.
2. Choose a Component button you want to program, (for example CBL for a cable box or
DVD for a DVD Player), on the Universal Remote Control and press this button.
3. Press and hold the SETUP button until the LED on the Remote Control flashes twice.
4. Refer to the table below that lists components and manufacturers and their relevant
program codes to find the programming code for the component and, using the number
buttons, enter the programming code. If the code is accepted the LED will flash twice
after the last digit of the programming code is entered.
5. Point the Universal Remote Control at the component and press the POWER button; the
component should power off. If the component does not turn off and there is more than
one programming code listed for the manufacturer and component, try the next code in
the list for that manufacturer until you find the correct one for your component.
Note: If you cannot find your manufacturer in the component list or if none of the programming
codes work, you can use the Remote Control to search for the correct component code.
See “Searching for Component Codes” below.
Component Program Codes
Use the codes in Appendix B to program the Universal Remote Control to work with your existing audio
and video components.
Searching for Component Codes
If you cannot find the manufacturer in the component list or the program code does not work, you can
use the remote control to search for the correct component code.
1. Turn on the component.
2. Press the matching component button on the Universal Remote Control
3. Press and hold the SETUP button until the LED flashes twice.
4. Press 9 9 1. After this number sequence has been entered the LED will flash twice.
5. Point the Universal Remote Control at the component and alternate between pressing the
POWER button and the component button on the remote control until the component turns off.
If the component still does not respond, clear the component button as described in the next three-step
process, then repeat the search procedure.
1. Make sure that the component is turned on.
2. Press and hold the SETUP button on the Universal Remote Control until the LED flashes twice.
3. Press 9 9 2, then press the component button on the Universal Remote Control twice.