Filter
Top Products
VIZIO RP56 User Guide
040330 37
Using the Picture-In-Picture (PIP) Mode
When the picture-in-picture mode (PIP) mode is active, one picture is displayed on the full screen (main
picture) and the other picture is displayed in a small window (sub-picture).
1. Press the TV component button.
2. Press the PIP button on the Universal Remote Control once to turn on the PIP mode. A small
window appears in one corner of the screen. The picture on the full screen is the main picture;
the picture in the window is the sub-picture.
3. When the PIP window is visible, press the STYLE button and the DLP TV will show the main and
sub pictures as a split screen with the screen being divided equally between the two pictures but
the content will be squeezed into the half width so that people will appear long and thin. Press
the STYLE button again and will change to POP (Picture-On-Picture) mode for which both
pictures are equal again but this time the height is adjusted to match the width of each picture so
that people are in the correct proportions. Press the STYLE button again and the format will
change to Main+3 mode which means there is a large main picture and three smaller sub pictures
stacked on the right side of the screen; each one of the sub pictures in turn becomes live for a
few seconds after which it freezes while the other two take their turn in being live. Press the
STYLE button again and the format will change to Main+7 mode which means there is one larger
main picture and seven smaller sub pictures arranged along the top and right edge of the screen
and they alternate between live and freeze as for the previous mode. Press the STYLE button
again and the format will change to Scan mode in which the screen is split into a grid of twelve
equal size pictures the first of which, (top left) is the main picture and the eleven sub pictures are
refreshed as in the previous two modes. Press the STYLE button again and the format will
change to PIP mode, which is where cycle of choices began.
4. Press the POSITION button one or more times to move the window to a different area of the
screen.
5. When the PIP window is visible, press the SWAP button and the main picture will switch to PIP
window and the PIP picture will replace it on the main screen. Press the SWAP button again and
the pictures will switch back again.
6. Press any one of the direct input buttons (TV, AV1, AV2, etc.) on the remote control to change
the video input source for the main picture.
7. Press the SOURCE button one or more times to select the video input desired for the sub picture.
Go to the Universal Remote Control section on pages 7, 8 and 9 for information about the other buttons
on the Universal Remote Control.