Filter
Top Products
VIZIO VL260M User Manual
34
www.VIZIO.com
Audio Menu
1. Press the MENU button on the remote control and the Picture menu will be shown on the screen.
2. Press
! or " on the remote control to highlight the Audio menu, and then press MENU to select it.
3. Press
! or " on the remote control to select an Audio menu option.
4. Once the menu option is highlighted, press $ or # on the remote control to adjust the setting.
5. Once the adjustments are completed press the LAST button repeatedly to exit the OSD completely.
Note: Equalizer adjustments are available for you to set them to your preferred settings. Equalizer will not
be available if SRS is on.
Equalizer
To select the options in the Equalizer sub-menu,
press the MENU button. A new menu will be
displayed showing the volumes of different
frequencies.
Starting from lowest to the highest, they are 120 Hz,
500Hz, 1.5 kHz, 5 kHz and 10 kHz.
1. Press " or # to select the frequency to be
adjusted.
2. Use $ or ! to adjust the selected
frequency to your preference. Values above
0 will boost the frequency and values below
0 will attenuate the frequency.
Note: The Equalizer adjustment will only be available when SRS TSHD is set to Off.
Balance
Adjust the sound to the left or the right.
SRS TSHD
This option sets the SRS TruSurround HD surround sound process. Choose from On or Off.
Note: When SRS TSHD is ON, Equalizer adjustments are not available.
Digital Audio Out
This option allows selection of the type of processing for the SPDIF (Optical connector) when used with a
Receiver/Amplifier/Home Theater system. Select to choose from OFF, Dolby Digital or PCM.
Speakers
Turn the internal speakers On or Off. You may want to turn the internal speakers off when listening to the
audio through your Home Theater System.
Lip Sync
Lip Sync is designed to adjust the audio of the program being viewed so that it matches the movement of
the lips of someone talking on the screen.
Reset Audio Mode
Return all Audio settings to factory default. A screen will come up to confirm your selection or to cancel it.
Press $ or # to make the selection, and then press MENU to accept it.