Filter
Top Products
VIZIO VP422 HDTV10A User Manual
Version 5/29/2008 13
www.VIZIO.com
1.5.1
1.5.11.5.1
1.5.1 Insertion of Batteries in the Remote Control
Insertion of Batteries in the Remote ControlInsertion of Batteries in the Remote Control
Insertion of Batteries in the Remote Control
Press and slide out the battery cover by following the direction shown by the molded arrow on the surface
of the cover.
Insert two AA batteries into the remote control. Make sure that you match the (+) and (-) symbols on the
batteries with the (+) and (-) symbols inside the battery compartment.
Press and slide the battery cover back into place.
Precautionary Tips for Inserting the Batteries:
Only use the specified AA batteries.
Do not mix new and old batteries. This may result in cracking or leakage
that may pose a fire risk or lead to personal injury.
Inserting the batteries incorrectly may also result in cracking or leakage
that may pose a fire risk or lead to personal injury.
Dispose of the batteries in accordance with local laws and regulations.
Keep the batteries away from children and pets.
1.5.2
1.5.21.5.2
1.5.2 Remote Control Range
Remote Control RangeRemote Control Range
Remote Control Range
Point the remote control at the remote control sensor to transmit the commands.
Do not place any obstacles between the remote control and the receiver window.
The effective range of the remote control is approximately 30 feet (10 meters) from the front of the
receiver window, 30° to the left and right, 20° up and down.
1.5.3
1.5.31.5.3
1.5.3 VIZIO Remote Control
VIZIO Remote ControlVIZIO Remote Control
VIZIO Remote Control Precautions
Precautions Precautions
Precautions
The remote control should be kept dry and away from heat sources. Avoid humidity.
If the TV responds erratically to the remote control or does not respond at all, check the batteries. If the
batteries are low or exhausted, replace them with fresh batteries.
When not using the remote control for a long period of time, remove the batteries.
Do not take the batteries apart, heat them, or throw them into a fire.
Do not subject the remote control to undue physical stress, such as striking or dropping it.
Do not attempt to clean the remote control with a volatile solvent. Wipe it with a clean, damp cloth.