Filter
Top Products
WB-31
Installation Instructions Page 7
WB-31 Installation
1. The reverse side of the mount must be mounted to the back plate that is attached to the wall. The
back of the mount contains an elongated rectangle (Figure 5). Referring to Figure 5, the back plate
receptacle must be placed over the top of the back plate, so that the entire mount “hangs” on the
back plate.
2. Locate the access hole at the bottom of the mount base. Install the M6 x 35mm set screw with the
M3 Allen wrench.
3. Turn the Allen wrench clockwise (viewed from below) until the screw is secure.
W
ARNING: Failure to fully tighten the locking screw may result in possible damage to your
display.
NOTE:
In reference to Figure 5, the dash lines represent the back plate that is mounted to
an existing surface.
Figure 5. WB-31 Installation