Filter
Top Products
11
4
3. Remove 1 lag bolt and 1 washer from the pouch labeled
LAG.
Place a bracket (part A) against the wall as shown, and use a
wrench to insert the lag bolt and washer into the anchor.
4. Push the bar through the opening in the bracket (part A) as
shown.
Push the other bracket (part A) onto the bar and hold it flat
against the wall. Ensure it is at least 16” from the other
bracket.
Snap on the leveler (part E) and level the bar.
Mark the location of the 3 holes on the brackets as shown.
3
Use Bottom Hole
Level Bar
16”
1 2
3
Make Mark