STEP 3A - MOUNTING TO A WALL WITH WOOD STUDS
The mount can be attached to walls with wood studs. The wall
covering (drywall, lath, plaster, etc.) may not be thicker than 1/2”.
If you are mounting on a concrete wall, go to Step 3B on page 10.
1. Use the electronic stud finder to locate two studs in the wall.
The studs should be approximately 16” apart. Use the pencil to
mark the areas of the wall where the studs are located.
Mark the left stud with an X at the height you want to mount the
TV.
2. Using the power drill and the 7/32” drill bit, drill into the X
mark you just made. Ensure you are drilling into the stud. Drill
the hole about 2” into the stud.
1
16”
2
7/32”
4
1
2
Make X Mark