5. Remove the bar, the leveler, and the unattached bracket (part A)
from the wall.
Using the power drill and the 7/32” drill bit, drill into the pencil
mark as shown. Ensure you are drilling into the stud. Drill
the hole about 2” into the stud.
6. Remove 1 lag bolt and 1 washer from the pouch labeled LAG.
Place the other bracket (part A) against the wall as shown, and
use a wrench to insert the lag bolt and washer into the hole you
just drilled. Do not insert the lag bolts completely. Leave 1/2” of
the bolt showing.
5
7/32”
Pencil Mark
6
6
Use Bottom Hole