4
3. Remove 1 lag bolt and 1 washer from the pouch labeled
LAG.
Place part A against the wall as shown, and use a wrench to
insert the lag bolt and washer into the hole you just drilled.
4. Push the bar through the opening in the bracket (part A) as
shown.
Push the other bracket (part A) onto the bar and hold it flat
against the wall. Ensure it is over the stud.
Snap on the leveler (part E) and level the bar.
Mark the location of the hole in the bracket as shown.
5
3
Use Bottom Hole
Push Bar Through
Level Bar
Make Mark