Filter
Top Products
Follow the steps below to raise the antenna for reflector, bracket, and LNB
assembly removal.
Pay attention to the pinch points as the antenna raises. See below.
Press [POWER], and hold for two seconds to turn
on the TRAV’LER
®
interface box. Wait until the
interface box finishes “connecting to antenna.”
The TRAV’LER antenna may enter the search
routine after ten seconds.
As the antenna raises, press [POWER] and [SELECT]
at the same time. The antenna should stop moving.
Unplug the TRAV’LER interface. Continue with
reflector removal.
If you cannot get the antenna to raise by following the above instructions,
you may have to raise the antenna with the emergency manual stow drive.
Emergency manual stow is meant as a last resort!
Unplug the TRAV’LER interface, and remove
the plastic bolt from the back of the mount.
Insert a
3
/
8
socket extension into
this auxiliary drive. Turn the
auxiliary drive counterclockwise to
raise the unit. Do not use a drill!
After raising the unit, continue with
the next section to remove the
reflector and LNB assembly.
Pinch Point
Top View Side View
Pinch Point
3
1
Plastic bolt
Raising the Antenna
2
1
2
3