Filter
Top Products
Remove the bolts holding the reflector bracket to the skew housing.
NOTE
If replacing a Slimline assembly with a
DISH assembly, remove and set aside
the stiffener plate inside the reflector bracket.
Remove the LNB arm assembly, and set aside.
NOTE
If replacing a Slimline assembly with a DISH assembly, remove the
four bolts from the adaptor plate, and remove the adaptor plate.
NOTE
If replacing a Slimline assembly with a DISH assembly, align the
small post on the back of the DISH 1000 adaptor plate with the small
groove on the skew assembly hub. Fit the small post into the groove. Secure
the adaptor plate to the hub with the four supplied ¼ inch Allen screws.
7
Stiffener
plate
6
Skew housing
Reflector bracket
Bolts
Adaptor plate
Installing the DISH Reflector and LNB Assembly
Groove
Post